Western Telematic IPS-400-CE Switch user manual

WTI Part No.: 13369


Internet Power Switches

Users Guide

Warnings and Cautions:



If Secure Racked units are installed in a closed or multi-unit rack assembly, they may require further evaluation by Certication Agencies. The following items must be considered.

The ambient within the rack may be greater than room ambient. Installation should be such that the amount of air ow required for safe operation is not compromised. The maximum temperature for the equipment in this environment is 45C. Consideration should be given to the maximum rated ambient.

Installation should be such that a hazardous stability condition is not achieved due to uneven loading.


Check nameplate ratings to assure there is no overloading of supply circuits that could have an effect on overcurrent protection and supply wiring.

Reliable earthing of this equipment must be maintained. Particular attention should be given to supply connections when connecting to power strips, rather than direct connections to the branch circuit.

No Serviceable Parts Inside; Authorized Service Personnel Only

Do not attempt to repair or service this device yourself. Internal components must be serviced by authorized personnel only.

Shock Hazard - Do Not Enter

Disconnect Power

If any of the following events are noted, immediately disconnect the unit from the outlet and contact qualied service personnel:

If the power cord becomes frayed or damaged.

If liquid has been spilled into the device or if the device has been exposed to rain or water.

IPS-400 / IPS-400-CE - Users Guide

FCC Part 15 Regulation

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Plug the equipment into an outlet on a circuit that is different from the one used by the

Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC rules. Operation of this device is subject to the following conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference that may cause undesired operation.

WARNING: Changes or modications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment

EMC, Safety, and R&TTE Directive Compliance

The CE mark is afxed to this product to conrm compliance with the following European

Community Directives:

Council Directive 89/336/EEC of 3 May 1989 on the approximation of the laws of

Member States relating to electromagnetic compatibility;

Council Directive 73/23/EEC of 19 February 1973 on the harmonization of the laws of

Member States relating to electrical equipment designed for use within certain voltage

Council Directive 1999/5/EC of 9 March on radio equipment and telecommunications terminal equipment and the mutual recognition of their conformity.

Industry Canada

This Class A digital apparatus meets all requirements of the Canadian Interference-Causing

Equipment Regulations.

Cet appareil numrique de la classe AB respecte toutes les exigences du Reglement Canadien sur le matriel brouilleur.

This product meets the applicable Industry Canada technical specications

Table of Contents

Introduction ... ... ... ... ... ... ... ... ... ... ... ... ... . . .

Unit Description ... ... ... ... ... ... ... ... ... ... ... ... ...

Quick Start ... ... ... ... ... ... ... ... ... ... ... ... ... ...

. Hardware Installation ... ... ... ... ... ... ... ... ... ... ...

. Apply Power to the IPS ... ... ... ... ... ... ... ... . . .

. Connect your PC to the IPS ... ... ... ... ... ... ... ...

3.2. Communicating wi