: Japan CBM Corporation
: CBM Bldg., 5-68-10, Nakano, Nakano-ku,
Tokyo 164-0001 Japan
Declare the Product
Terminal Slip Printer
(S. No.9890001 - )
Conform to the following Standards
: 1994 Class B
: 1995 4KV CD, 8KV AD
: 1995 3V/m, 80MHz-1000MHz AM 1KHz 80%
: 1995 3V/m,895MHz-905MHz
(Pulse 200Hz,duty cycle50%)
: 1995 1.0KV(AC Mains), 0.58KV (Signal Lines)
: 1995 1KV Differential mode, 2KV Common mode
: 1996 3V, 0.15MHz-80MHz AM 1KHz 80%
: 1993 50Hz, 3A/m
: 1991-80%, 10ms/-60%,100ms/-100%, 5000ms
The product complies with the requirements of the Low Voltage Directive 73/23/EEC,
93/68/EEC and the EMC Directive 89/336EEC, 92/31/EEC, 93/68EEC
Place : Tokyo, Japan
Full Name : Mikio Moriya
European Contact :
Norco Declaration AB
Box 7146 S-250 07 Helsingborg Sweden
This declaration is applied only for 230V model.
: General Manager
R & D Department
IMPORTANT SAFETY INSTRUCTIONS
Read all of these instructions and save them for future reference.
Follow all warnings and instructions marked on the product.
Unplug this product from the wall outlet before cleaning. Do not use liquid or aerosol cleaners.
Use a damp cloth for cleaning.
Do not use this product near water.
Do not place this product on an unstable cart, stand or table. The product may fall, causing serious damage to the product.
Slots and openings on the back or bottom of the case are provided for ventilation. To ensure reliable operation of the product and to protect it from overheating, do not block or cover these openings.
The openings should never be blocked by placing the product on a bed, sofa, rug of other similar surface. This product should never be placed near or over a radiator or heater. This product should not be placed in an built-in installation unless proper ventilation is provided.
This product should be operated from the type of power source indicated on the marking label. If you re not sure of the type of power available, consult your dealer or local power company.
Do not allow anything to rest on the power cord. Do not place this product where the cord will be walked on.
If an extension cord is used with this product, make sure that the total of the ampere ratings of the products plugged into the extension cord does not exceed the extension cord ampere rating. Also, make sure that the total of all products plugged into the wall outlet does not exceed 15 amperes.
Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short out parts that could result in a risk of fire or electric shock. Never spill liquid of any kind on the product.
Except as explained elsewhere in this manual, do not attempt to service this product by yourself.
Opening and removing the covers that are marked Do Not Remove may expose you to dangerous voltage points or other risks. Refer all servicing on those compartments to service personnel.
Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:
A. When the power cord or plug is damaged or frayed.
B. If liquid has been spilled into the product.
C. If the product has been exposed to rain or water.
D. If the product does not operate normally when the operating instructions are followed. Adjust only those controls that are covered be the operating instructions since improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal operation.
E. If the product has been dropped or the cabinet has been damaged.
F. If the product exhibits a distinct change in performance, indicating a need for service.
Please keep the poly bag which this equipment is packed in away from children or throw it away to prevent children from putting it on. Putting it on may cause suffocation.
Lesen Sie die nachfolgenden Anweisungen sorgfltig durch und bewahren Sie sie auf.
Befolgen Sie alle auf dem Drucker vermerkten Hinweise und Anweisungen. Vor dem Reinigen grundstzlich Stecker aus der Steckdose ziehen. Keine Flssigkeiten oder Aerosolreiniger benutzen. Nut mit einem feuchten Tuch abwischen.
Der Drucker darf nicht in der Nhe von Wasser aufgestellt werden.
Drucker nicht auf einem unstabilen Wagen, Stand oder Tisch aufstellen. Der Drucker knnte herunterfallen und dabel besch