Sony DSR-PD100AP Camcorder user manual

Declaration of Conformity

Trade Name:

Model No.:

Responsible Party:


Sony Electronics Inc.

1 Sony Drive, Park Ridge, NJ,

Telephone No.:


This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions.:

(1) This device may not cause harmful interference, and (2)this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

For the Customers in Europe (DSRPD100AP)

The electromagnetic fields at the specific frequencies may influence the picture and sound of this digital camcorder.




A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience.

Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI

For the Customers in CANADA

This Class B digital apparatus complies with Canadian

Before you begin

This product with the CE marking complies with both the EMC Directive (89/336/EEC) and Low Voltage

Directive (73/23/EEC) issued by the Commission of the

European Community.

Compliance with these directives implies conformity to the following European standards:

EN60065:Product Safety (supplied AC Adaptor only)

EN55103-1:Electromagnetic Interference (Emission)