Mitsubishi Electronics LVP-X100A Projector Accessories user manual

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK)

NO USER-SERVICEABLE PARTS INSIDE

REFER SERVICING TO QUALIFIED

SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated dangerous voltage within the products enclosure that may be of sufficient magnitude to constitute a risk of electric shock.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS

APPLIANCE TO RAIN OR MOISTURE.

TO PREVENT ELECTRIC SHOCK DO NOT USE THIS (POLARIZED)

PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT

BLADE EXPOSURE.

SINCE THIS PROJECTOR IS PLUGGABLE EQUIPMENT, THE

SOCKET-OUTLET SHALL BE INSTALLED NEAR THE EQUIPMENT

AND SHALL BE EASILY ACCESSIBLE.

COMPLIANCE NOTICE OF FCC

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled Digital Apparatus, ICES-003 of the Department of Communications.

Changes or modifications not expressly approved by Mitsubishi could void the user's authority to operate this equipment.

COMPLIANCE NOTICE OF INDUSTRY CANADA

This Class [A] digital apparatus meets all requirements of the Canadian InterferenceCausing Equipment Regulations.

Use the attached specified power-supply cord. If you use another cord, it may cause interference with radio and television reception.

Use the attached VGA cable, RS-232C cable with this equipment so as to keep interference within the limit of a Class A device.

The projector automatically shuts off when the lamp is used up in about 1,300 hours and not used until lamp replacement.

DO NOT LOOK DIRECTLY INTO THE LENS WHEN PROJECTOR IS IN THE POWER

Important safeguards ...

Overview of the projector ...

Overview of the remote control ...

Battery installation ...

Preparing the projector for operation ...

Basic connections...

Cables and adapters ...

Projector + IBM PC or IBM PC compatibles (DOS) ...

Projector + Macintosh ...

Projector + NEC PC-and EPSON PC series ...

Projector + AV equipment ...

To operate projector power ON ...

Menu operation...

MENU layers ...

Basic operation ...

NORMAL menu ...

GAMMA CORRECTION menu ...

ENHANCED menu ...

POINTER menu ...

AUDIO menu ...

OPTION menu ...