USE AND CARE GUIDE
LECTRIQUE OU GAZ
Table of Contents
CHECK YOUR VENT SYSTEM
FOR GOOD AIR FLOW...
USE SENSOR DRY/AUTOMATIC DRY CYCLES FOR
BETTER FABRIC CARE AND ENERGY SAVINGS...
CONTROL PANEL & FEATURES...
USING YOUR DRYER...
ASSISTANCE OR SERVICE... BACK COVER
Table des matires
SCURIT DE LA SCHEUSE...
VRIFICATION DUNE CIRCULATION DAIR
ADQUATE POUR LE SYSTME DVACUATION ...16
UTILISATION DES PROGRAMMES DE
SCHAGE PAR DTECTION/PROGRAMMES
AUTOMATIQUES POUR UN MEILLEUR SOIN
DU TISSU ET DAVANTAGE DCONOMIES
TABLEAU DE COMMANDE
GUIDE DE PROGRAMMES...
UTILISATION DE LA SCHEUSE...
ENTRETIEN DE LA SCHEUSE...
SERVICE... COUVERTURE ARRIRE
IMPORTANT: The gas installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1/NFPA 54, or the Natural Gas and Propane Installation Code, CSA B149.1.
The dryer must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National
Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, Part 1, CSA C22.1.
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings exactly could result in serious injury, death or property
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electrical switch; do not use any phone in your building.
Clear the room, building, or area of all occupants.
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
If you cannot reach your gas supplier, call the fire department.
Installation and service must be performed by a qualified installer, service agency, or the gas supplier.
CHECK YOUR VENT SYSTEM FOR GOOD AIR FLOW
Maintain good air flow by:
? Cleaning your lint screen before each load.
? Replace plastic or foil vent material with 4" (102 mm) diameter heavy, rigid vent material.
? Use the shortest length of vent possible.
? Use no more than four 90 elbows in a vent system; each bend and curve reduces air flow.
Good air flow
Along with heat, dryers require good air flow to efficiently dry laundry. Proper venting will reduce your drying times and improve your energy savings. See Installation Instructions.
The venting system attached to the dryer plays a big role in good air flow. Blocked or crushed vents as well as improper venting installation will reduce air flow and dryer performance.
Service calls caused by improper venting are not covered by the warranty and will be paid by the customer, regardless of who installed the dryer. To clean or repair venting, contact a venting specialist.
Remove lint and debris from the exhaust hood.
? Remove lint from the entire length of the vent system at least every 2 years. When cleaning is complete, be sure to follow the Installation Instructions supplied with your dryer for final product check.
? Clear away items from the front of the dryer.
USE SENSOR DRY/AUTOMATIC DRY CYCLES FOR BETTER
FABRIC CARE AND ENERGY SAVINGS
Use the Sensor Dry/Automatic Dry cycles to provide the most energy savings and enhanced fabric care from the dryer. During
Sensor Dry/Automatic Dry cycles, drying air temperature or moisture level is sensed in the load. This sensing occurs throughout the drying cycle and the dryer shuts off when the load reaches the selected dryness.
With Timed Dry, the dryer runs the amount of time set and sometimes results in shrinkage, wrinkling, and static due to over-drying.
Use Timed Dry for the occasional damp load t