LINEAR MDRM Radio user manual

INSTR,INST,MDR

Linear P/N: 210188 B

Material: 20 Lb. Mead Bond

Size: 8.500" x 11.000"

Ink: Black

Scale: 1-1

Side 1 of 2

STEP 1A MDR/MDRNR/MDR2 Three-terminal Operator

Installation. Hold receiver up to back of operator. Connect

Terminals 1, 2 & 3 on the receiver to Terminals 1, 2 & 3 on the

MDR - Single-channel external receiver with relay output.

MDRM - Single-channel internal receiver (fits operators with recessed receivers) with solid state output.

MDRNR - Single-channel external receiver with solid state output.

MDR2 - Two-channel external receiver with relay outputs.

MDRM2 - Two-channel internal receiver (fits operators with recessed receivers) with solid state output on channel one and relay output on channel two.

INSTALL 3 SCREWS

TO OPERATOR

STEP 2 MDR2/MDRM2 Two-channel Receiver Installation.

Connect the receiver to the operator as described in the previous step. The channel-two pigtail wires can be connected to the operators light toggle terminals or to an external device.

RECEIVER FITS INTO

BACK OF OPERATOR

1, 2 AND 3

STEP 3 Optional Receiver Mounting Bracket. If the receiver isnt going to be mounted directly to the operator terminals, an optional mounting bracket is supplied. It can be installed three ways onto the MDR or MDR2 case. Screw the bracket to a wall or stud and snap the receiver onto it.

CONNECT BROWN TO COMMON GROUND

CONNECT ORANGE TO LIGHT TERMINAL

GROUND (#1)

BRACKET CAN

MOUNT IN THREE

CORNER HOLE IS

SHARED FOR

LOCATIONS 2 & 3

LOCATION 2

LOCATION 1

#TF524 24VAC, .5VA

TRANSFORMER

STEP 4A MDR/MDRNR/MDR2 Program button and LED

Location. Locate the program button and LED on the side of the receiver case.

CHANNEL ONE

PROGRAMMING

PROGRAMMING

3-TERMINAL

RECESSED RECEIVER

LOCATION 3

CHANNEL TWO

PROGRAMMING

BUTTON (ONLY

STEP 4B M D R M / M D R M 2 P r o g r a m b u t t o n a n d L E D

Location. Locate the program button and LED on the back of the receiver case.

C H A N N E L O N E

P R O G R A M M IN G

B U T T O N

INSTR,INST,MDR

Linear P/N: 210188 B

Material: 20 Lb. Mead Bond

Size: 8.500" x 11.000"

Ink: Black

Scale: 1-1

Side 2 of 2

C H A N N E L T W O

P R O G R A M M IN G

B U T T O N

P R O G R A M M IN G

STEP 6 Add additional transmitters. Repeat Step 5 for each transmitter used with this receiver. Be sure to press the receivers program button each time a new transmitter or a different transmitter button on a multi-button transmitter is

If the LED doesnt come on when the receivers program button is pressed, the receivers memory is full (10 transmitters total). Use the erase funct