Kenmore 51122 13.7" Laundry Pedestal w/ Storage Drawer - White user manual

Give Your Washer and Dryer a Lift The 51122 13.7" white laundry pedestal with storage drawer keeps all your laundry items organized in an easy-to-access spot. Elevate your washer or dryer to the ideal height with this 13.7” high pedestal. Features and easy-to-access drawers to keep your laundry items organized & out of the wayElevates washer and dryer to optimal height for extra convenienceAllows for less bending and reaching

Identify the different locations for the washer and dryer legs. If the legs are not in the proper locations, the machine will not align properly and cannot be anchored to the pedestal.

WASHER INSTALLATION

(See page 4 for dryer instructions.)

5 Level the washer on the pedestal by adjusting the

7 Move the washer to the desired place.

NOTE: The appliance and pedestal assembly must be placed on a solid and level floor for proper operation.

Adjust the legs of the appliance and pedestal by turning with a wrench. Then, tighten the lock nut against the base of the pedestal with the wrench while holding the leg to make sure it does not turn.

Adjustable feet

Adjustable feet

NOTE: Diagonal Check

Once the pedestal feet are adjusted, rock the washer very firmly in a diagonal direction. If one direction moves more than the other, readjust the front feet until both directions are

NOTE: To make sure that the washer is properly level, run the washer with a test load: place approximately 6 pounds (3 kg) of laundry in the machine. Then press POWER, select

RINSE & SPIN or EXPRESS WASH cycle, and then press the START/PAUSE button. Verify that the washer does not rock or vibrate excessively during the spin cycle. If the washer vibrates or shakes, adjust the leveling feet while the washer is spinning to minimize the vibration.

6 Check the alignment of the washer with the pedestal.

Make sure the washer base brackets align with the brackets on the pedestal, then install 4 screws at each corner to securely attach the appliance to the

NOTE: If the screws are not installed properly, noise and vibration may result.

DRYER INSTALLATION

(See page 3 for washer instructions.)

5 Insert the T-clip of the 4 retainers into the dryer base

8 Move the dryer to the desired location. as shown. Press up on the back of the clip and pull outward to lock into place.

NOTE: The appliance and pedestal assembly must be placed on a solid and level floor for proper operation.

Adjust the legs of the pedestal using the wrench

supplied. Tighten the lock nuts with the wrench.