Invacare 1301RTS Bathroom Aids user manual

ALWAYS make sure that the Raised Toilet Seat is securely in place and stable before each use. Although the Raised Toilet Seat is designed for use on most popular toilets, it may not work on certain unusual or artistic bowls.

Be sure that the users weight is centered on the Raised Toilet Seat as the seat may tip if the user leans too far forward or from side to side.

Invacare recommends the use of a toilet safety frame or grab bars in addition to the

Raised Toilet Seat.

3 Removing/Installing the Raised Toilet Seat

For this section, refer to FIGURE 1 on page 3.

To remove the Raised Toilet Seat, reverse this procedure.

The existing toilet seat and lid can be flipped up or removed depending upon the amount of usage.

Perform one of the following procedures depending on the Raised Toilet Seat type:

Model 1300RTS - Raised Toilet Seat

Put the Raised Toilet Seat in place on the toilet bowl with the tall end of the seat towards the back of the toilet bowl. Refer to DETAILA.

Properly seat the inner ring inside the toilet bowl.

Check the stability of the Raised Toilet Seat. Realign and/or adjust as necessary.

Model 1301RTS - Raised Toilet Seat with Adjustment Knob

Put the rear wings of the Raised Toilet Seat in place underneath the 1-3/4 inch toilet lip at the back of the toilet bowl.

Rotate the Raised Toilet Seat down until the front of the seat rests on the toilet bowl.

If necessary, rotate the adjustment knob counterclockwise until the bracket fits inside the toilet bowl.

Turn the adjustment knob clockwise to tighten the bracket against the inner surface of the toilet bowl.

Check the stability of the Raised Toilet Seat. Realign and/or adjust as necessary.

Raised Toilet Seat

Part No 1167433

Model 1302RTS - Raised Toilet Seat with Adjustment Knob and Arms

Remove the plastic from the arms.

Install the arms onto the Raised Toilet Seat.

A. Depress both snap buttons on the arm and insert the arm into the mounting tubes.

Slide the snap buttons to the appropriate holes in the mounting tubes.

There will be an audible click. Ensure the snap buttons fully protrude through the holes in the mounting tubes.

Repeat STEP 2 to install the opposite arm onto the Raised Toilet Seat.

Put the rear wings of the Raised Toilet Seat in place underneath the 1-3/4 inch toilet lip at the back of the toilet bowl.

Rotate the Raised Toilet Seat down until the front of the seat rests on the toilet bowl. If necessary, rotate the adjustment knob counterclockwise until the bracket fits inside the toilet bowl.

Turn the adjustment knob clockwise to tighten the bracket against the inner surface of the toilet bowl.

Adjustment

Rear Seat Wing

Raised Toilet

Seat (installed)

1-3/4 inch