GE® 230 Volt Electronic Room Air Conditioner AEH25DM user manual

Slide-out chassis.
Care and Cleaning

? Never unplug your air conditioner by pulling on the power cord. Always grip plug firmly and pull straight out from the receptacle.

? Replace immediately all electric service cords that have become frayed or otherwise damaged. A damaged power supply cord must be replaced with a new power supply cord obtained from the manufacturer and not repaired. Do not use a cord that shows cracks or abrasion damage along its length or at either the plug or connector end.

? For your safetydo not store or use combustible materials, gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance.

? All air conditioners contain refrigerants, which under federal law must be removed prior to product disposal. If you are getting rid of an old product with refrigerants, check with the company handling disposal about what to do.

Installation

Instructions

HOW TO CONNECT ELECTRICITY

Do not, under any circumstances, cut or remove the third (ground) prong from the power cord. For personal safety, this appliance must be properly

DO NOT use an adapter plug with this appliance.

Consumer Support Troubleshooting Tips

NOTE: We strongly recommend that any servicing be performed by a qualified individual.

The power cord of this appliance is equipped with a 3-prong (grounding) plug which mates with a standard 3-prong (grounding) wall outlet to minimize the possibility of electric shock hazard from this appliance.

Power cord includes a current interrupter device. A test and reset button is provided on the plug case. The device should be tested on a periodic basis by first pressing the TEST button and then the RESET button while plugged into the outlet. If the TEST button does not trip or if the RESET button will not stay engaged, discontinue use of the air conditioner and contact a qualified service technician.

Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.

Where a 2-prong wall outlet is encountered, it is your personal responsibility and obligation to have it replaced with a properly grounded

3-prong wall outlet.

The air conditioner should always be plugged into its own individual electrical outlet which has a voltage rating that matches the rating plate.

This provides the best performance and also prevents overloading house wiring circuits which could cause a fire hazard from overheated wires.

See the Installation Instructions, Electrical

Requirements section for specific electrical

People who looking for AEH25DM also looking GE Profile™ 1.6 Cu. Ft. Spacemaker® XL1600 Over-the-Range Non-Vented Microwave Oven JVM1661BB user manual, Adora series by GE® 30" Free-Standing Electric Convection Range with Warming Drawer JB710TTWW user manual, GE® Zoneline Value Series Heat Pump Unit AZ32H12E3B user manual, Kenmore 81414 400 Series Bagged Canister Vacuum - Red user manual, GE Zoneline® Deluxe Series Heat Pump Unit with ICR, 230/208 Volt AZ61H15DAD user manual, GE® ENERGY STAR® 20.3 Cu. Ft. Bottom Freezer Refrigerator GBSC0HBXBB user manual, GE Profile 7.5 cu. ft. stainless steel capacity frontload dryer with Steam PFDS455GLMG user manual, GE Profile™ 30" Free-Standing Spectra™ Convection Range JBP95BFBB user manual, GE Profile™ Built-In Dishwasher PDW7800RBB user manual

connection requirements.

EXTENSION CORDS

Instructions

DO NOT use an extension cord with any of the

230/208 vol