7 days a week.
IMPORTANT SAFETY INFORMATION
READ ALL SAFETY INFORMATION
BEFORE USING
This air conditioner must be properly installed in accordance with the Installation Instructions before it is used.
Repair or replace immediately all electric service cords that have become frayed or otherwise
Extension Cord
Adapter Plug
This is a temporary method.
UL-listed adapters are available at most hardware stores.
Turn the mode control knob to OFF and unplug your air conditioner before making any repairs.
NOTE: We strongly recommend that any servicing be performed by a qualified individual.
If an extension cord is required to reach the nearest wall receptacle, use only a UL-listed, 3-wire, grounded, 14 gauge, 15A, 125V appliance extension cord. For models with nameplate ratings greater than 12 amperes, do not use an extension cord.
Because most 2-prong outlets are not grounded, we strongly advise against using an adapter plug.
However, a temporary connection may be made where local codes permit and if the 2-prong wall outlet is properly grounded.
When you plug the adapter in, make sure the larger prong goes into the larger slot to provide the proper polarity for the power cord.
DO NOT use an extension cord with any of the 208/230-volt models.
FOR PROPER GROUNDING:
1 Screw the adapter to the outlet, using the outlet cover screw.
2 Ground the outlet through the house
When disconnecting the power cord from the adapter, hold the adapter close to the outlet while pulling the plug out. If this is not done, the grounding connector is likely to break with repeated use.
If the grounding connector breaks,
DO NOT USE the air conditioner until a proper ground has again been made.
SAVE THESE INSTRUCTIONS
Operating Instructions
MODE CONTROLS conditioner
TEMP CONTROLS
Your model will look like one of these.
Mode Control
HIGH COOL, MED COOL and LOW COOL provide cooling with different fan speeds.
FAN ONLY provides air circulation and filtering without cooling.
If you move the switch from a cool setting to
OFF or to a fan setting, wait at least 3 minutes before switching back to a cool setting.
Temp Control
The temp control is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the same level of comfort. The higher the number selected, the cooler the indoor air will become.
The blower runs as long as the Mode Control is not on OFF.
Cooling Descriptions
FOR NORMAL COOLING
Select MED COOL with the temp at 4 or 5.
FOR MAXIMUM COOLING
Select HIGH COOL with the temp at 8 or 10.
FOR QUIETER & NIGHTIME COOLING
Select LOW COOL with the temp at 3 or 4.
ENERGY SAVING
Your model will look like one of these.
