GE Profile™ 30" Slide-In Gas Range JGS905SEKSS user manual

TrueTemp system.
Troubleshooting Tips

? Do not try to light any appliance.

? Do not touch any electrical switch; do not use any phone in your building.

? Immediately call your gas supplier from a neighbors phone. Follow the gas suppliers instructions.

? If you cannot reach your gas supplier, call the fire department.

Consumer Support

Installation and service must be performed by a qualified installer, service agency or the gas supplier.

For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property damage, personal injury, or loss of life.


To prevent accidental tipping of the range, attach it to the wall or floor by installing the Anti-Tip device

If the Anti-Tip device supplied with the range does not fit this application, use the universal Anti-Tip device WB2X7909.

To check if the device is installed and engaged properly, remove the storage drawer and inspect the rear leveling leg. Make sure it fits securely into the slot.

If you pull the range out from the wall for any reason, make sure the device is properly engaged when you push the range back against the wall. If it is not, there is a possible risk of the range tipping over and causing injury if you or a child stand, sit or lean on an open door.


The California Safe Drinking Water and Toxic Enforcement Act requires the Governor of California to publish a list of substances known to the state to cause birth defects or other reproductive harm, and requires businesses to warn customers of potential exposure to such substances.

The fiberglass insulation in self-clean ovens gives off a very small amount of carbon monoxide during the cleaning cycle. Exposure can be minimized by venting with an open window or using a ventilation fan or hood.

Troubleshooting Tips

Gas appliances can cause minor exposure to four of these substances, namely benzene, carbon monoxide, formaldehyde and soot, caused primarily by the incomplete combustion of natural gas or

LP fuels. Properly adjusted burners, indicated by a bluish rather than a yellow flame, will minimize incomplete combusti