Use and Care Guide.
WARN ING Electrical Information
These guidelines must be followed to ensure that safety mechanisms in the design of this freezer will operate properly.
Refer to the serialplate for correct electrical rating.
The power cord of the appiiance is equipped with a three prong plug for your protection against shock hazards. It must be plugged directly into a properly groundedthree prong receptacle, protected with a 15 amp timedelay fuse or circuit breaker. The receptacle must be installed in accordance with local codes and ordinances. Consult a qualified electrician.
Receptacles protected by Ground Fault Interrupters
(GFI) are NOT RECOMMENDED. DO NOT USE AN
EXTENSION CORD OR ADAPTER PLUG.
If voltage varies by 10% or more, freezer performance may be affected. Operating freezer with insufficient power can damage the motor. Such damage is not covered under the warranty. If you suspect your household voltage is high or low, consult your power company for testing.
To prevent the freezer from being turned off accidentically, do not plug unit into an outlet controlled by a wall switch or pull cord.
Do not pinch, knot, or bend the cord in any manner.
This Owners Guide provides specific operating instructions for your model. Use the freezer only as instructed in this Owners Guide. Before starting the freezer, follow these important first steps.
Choose a place that is near a grounded electrical outlet. Do Not use an extension cord or an adapter
For the most efficient operation, the freezer should be located where surrounding temperatures will not exceed 110F (43C). Temperatures of 32F (0C) and below will NOT affect freezer operation. Additional compressor heaters are not recommended.
Allow space around the unit for good air circulation.
Leave a 3 inch (75 mm) space on all sides of the freezer for adequate circulation.
To defrost freezer, always unplug unit first.
Never unplug the freezer by pulling on the cord.
Always grip the plug firmly, and pull straight out from the receptacle.
Turning the temperature c