Electrolux E30MO65GSS Microwave Oven User Manual

Oven Cavity Dimensions

Overall Exterior Dimensions

Approved for Under-Counter Installation

Approved for Electric Single Oven Combination Installation*

Power Cord Location

Shipping Weight (Approx.)

Right Bottom Rear use on adequately wired 120V, dedicated circuit having 2-wire service with a separate ground wire. Appliance must be grounded for safe operation.

* Approved to be used in combination with any Electrolux ICON Electric Single

Wall Oven and/or Warmer Drawer. (Not approved to be used above any gas wall oven.)

30" Trim Kit (E30MO65TMK) is supplied and includes Stainless Steel Faceplate,

Exhaust Duct Assembly and Bottom Duct Assembly shipped in separate box.

NOTE: Always consult local and / or national electric codes. Refer to Product Installation

Specifications subject to change.

Cooking Flexibility

Cooking is easier and faster in an appliance that combines both microwave technology and high-speed convection. From warming coffee to roasting, baking or broiling youll capture conventional flavors in less time.

Built-In Convection Microwave

E30MO65GSS designer series

Exhaust Duct

*Note: When used in combination with another Electrolux ICON built-in product, a minimum clearance of 3 1/8" required from bottom of Built-In Microwave cutout to top edge of companion products faceplate, leaving a 2" visible gap between both product faceplates

Allow at least

19" clearance for door

depth when open

26 1/2" min.

Full plywood base required to support

Bottom Duct Assembly grounded outlet

Bottom Duct Assembly

Outlet should

NOT be located within shaded

20 1/8" min.

30" Built-In Convection Microwave Specifications

Product

Voltage

Weight 60 Lbs.

Rating 120V / 60 Hz / 15 Amps

Connected Load (kW Rating) @ 120 Volts = 1.55 kW

(For use on adequately wired 120V, dedicated circuit having 2-wire service with a separate ground wire. Appliance must be grounded for safe operation.)

Amps @ 120 Volts = 13 Amps

Always consult local and /or national electric codes.

Allow 19" minimum clearance for 90 door swing.

Built-In installation requires use of 30" Trim Kit (E30MO65TMK) which is supplied and includes Stainless Steel Faceplate, Exhaust Duct

Assembly and Bottom Duct Assembly shipped in separate box.

Minimum 20-1/8" deep oven cutout dimension is critical for proper installation for oven and faceplate to fit flush against cabinet front.

Full base of solid plywood or similar material required, capable of supporting 100 Lbs.

Grounded must be level and front of cabinet square for proper operation. outlet should NOT be located in shaded area, as indicated.

Can NOT be installed above any gas wall oven.

Built-In Convection Microwave can be built in alone or is approved to be used in combination with any Electrolux ICON Electric Single

Wall Oven and / or Warmer Drawer. (Refer to model-specific Combination

Installation Specifications pages on web.)

When used in combination with another Electrolux ICON built-in product, a minimum clearance of 3-1/8" required from bottom of Built-In