Can shock, burn, or cause death. flow at 75 PSI.
Install pressure relief valve in discharge pipe.
Release all pressure on system before working on any component. instrucmanual connecting tor to power use padlocks instructions for all wiring.
Ground pump before connecting to power this pump. nameplate. connecting of passing condition.
Wire motor for correct voltage. See "Electrical" of this manual
Make workshop_ childproof; remove starter keys. instructions all safety or damaged
Relief valve must damage if ignored. or can cause minor labels in good if ignored.
The label NOTICE but not related to hazards. signal words and master
Wear safety at all times all unused
[_l_ WARNING] uncluttered components. and propedy tools and equipment. at a safe distance at 75 PSl (517 kPa) from the work valve capable is installed.
Do not allow pump, pressure tank, piping, or any other system containing water to freeze. Freezing may damage system, leading to injury or flooding. Allowing pump or system components t_ freeze will void warranty. and system of passing as a booster at high temperature will be too hot to touch. It is protected t_'om heat damage during by an automatic internal cut oiff'switch.
Before handling pump or motor, stop motor and allow it tO cool for 20 minutes.
TABLE I - Pump Performance
Pumping Depth in Feet
We suggest you take a few minutes to read the instructions contained in this manual before installing and using your pump. This will help you obtain the full benefits of the quality and convenience built into this equipment.
It will also help you avoid any needless service expense from causes beyond our control which naturally cannot be covered in our warranty.
RULES FOR SAFE INSTALLATION