Braun 4775 Electric Shaver User Manual

On off

5713452_4775_AMEE_S4-42 Seite 4 Dienstag, 21. Oktober 2003 8:36 08

Our products are designed to meet the highest standards of quality, functionality and design. We hope you enjoy your new Braun

Your shaver is provided with a special cord set with integrated Safety Extra Low Voltage power supply. Therefore you must not exchange or manipulate any part of it. Otherwise there is a risk of electric shock.

Description

Shaver foil

Cutter block

Release button

on/off switch

Long hair trimmer

Dual function light green: charging red: low-charge

7 Special cord set

The best environmental temperature for charging is between 15 C and 35 C.

Using the special cord set, connect the shaver with an electrical outlet. The shaver must be switched off.

When charging for the first time, leave the shaver to charge continuously for 4 hours.

Subsequent charges will take about 1 hour.

As soon as you start charging the shaver, the green charging light (6) comes on.

When the batteries are fully charged, the green light goes off. If it comes on again while connected to an electrical outlet, this indicates the shaver is recharging to maintain its full capacity.

Once the shaver is completely charged, discharge the shaver through normal use.

Then recharge to full capacity.

A full charge will give up to 40 minutes of cordless shaving time depending on your beard growth. However, the maximum battery capacity will only be reached after several charging/discharging cycles.

When the batteries are running low, the

dual function light (6) turns red (provided the shaver is switched on). The red light indicates the shaver capacity has dropped below 20%, which is sufficient for 2 to 3

If the rechargeable batteries are discharged, you can shave without charging by connecting the shaver to an electrical outlet via the special cord set.

Press the on/off switch (4) to turn the shaver

Trimmer: When the long hair trimmer (5) is activated, it allows controlled trimming of moustache or sideburns.

Tips for the perfect shave

We recommend that you shave before washing, as the skin tends to be slightly swollen after washing.

Hold the shaver at right angles (90) to the skin. Stretch the skin and shave against the direction of beard growth.

To maintain 100% shaving performance, replace your foil and cutter block every

18 months or when worn.

Always unplug the appliance before cleaning.

Regular cleaning ensures better shaving performance. Rinsing the shaving head after each shave under hot running water is an easy and fast way to keep it clean:

Switch the shaver on (cordless) and rinse the shaving head under hot running water.

A natural based soap may also be used

5713452_4775_AMEE_S4-42 Seite 5 Dienstag, 21. Oktober 2003 8:36 08 provided it contains no particles or abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.

Next switch the shaver off and press the release buttons. Lift the shaver foil off and pull the cutter block out. Then leave the disassembled shaving parts to dry.

However, if you prefer to dispose of the appliance yourself, remove the batteries as shown on page 29.

Alternatively, you may clean the shaver using the brush provided:

Switch the shaver off. Press the release buttons and lift shaver foil off.

Using the brush, clean the cutter block and the inner area of the shaver head. However, do not clean the shaver foil with the brush as this may damage the foil.

This product conforms to the EMCDirective 89/336/EEC and to the Low

Voltage Regulation (73/23 EEC).

Subject to change without notice.

Electric specifications see printing on the special cord set.

Keeping your shaver in top shape

About every four weeks, clean the cutter block with Braun cleaning agents. Put a drop of light machine oil onto the long hair trimmer and the shaver foil.