Boston Acoustics VOYAGER 5 Portable Speaker user manual

8 ohms x 2 copolymer cone with butyl rubber surround

7 (180mm)

1" (25 mm)

1" (25 mm)

3/4" (19mm)

3/4" (19mm)

(2) 1" (25mm)

Crossover Frequency

Dimensions without bracket (HxWxD)

141/2 x 97/8 x

368x251x212

61/2 (165mm) 51/4 (135mm) 41/2 (115mm) 61/2 (165mm)

13 x 9 x 73/4

330x229x197

111/4 x 81/4 x 7 93/4 x 67/8 x 57/8

286x210x177

238x175x149

9 x 13 x 73/4

229x330x197

Grille & Bracket corrosion resistant powder-coated powder-coated powder-coated powder-coated powder-coated polypropylene polypropylene polypropylene polypropylene polypropylene

How to Connect Your Speakers

You need to wire your speakers correctly to obtain the best sound quality and a proper stereo image. Wiring should take a few minutes, but its important to do it carefully, since incorrect wiring

(such as reversed connections) can result in a poor stereo soundstage or poor bass. We recommend 18 gauge (or heavier) lamp cord or speaker wire for runs of up to 25 feet (8m), and thicker 16 gauge for longer runs. Strip 1 /2" (12mm) of insulation off the ends of each speaker cable to expose the two conductors, and tightly twist the wire strands. In installations where wiring is run on or through a building, use appropriate weatherproof wire that complies with local codes. See your dealer or other knowledgeable person for recommendations on suitable wiring.

To prevent electrical shock hazard, always switch off the amplifier or receiver when making connections to the speaker. When making all connections, be sure to connect the + (red) on the speaker to the + (red) on the amplifier, and the - (black) on the speaker to the (black) on the amplifier.

IMPORTANT: Typically, one side of the wire is smooth. Connect this side to the (black) connection. The other side has a rib or stripe or other marking. Connect this to the

+ (red) connection.

Using the five-way binding posts: The binding posts permit easy connection to banana plugs, spade lugs, and bare wire. Insert the wire in the hole and tighten.

Thank you for purchasing these new Voyager speakers. Combining the famous Boston sound with the latest and best weather resistance and manufacturing methods, the Voyagers are ideally suited to anything you can throw at them. Try outdoor use sun, rain, snow, heat, and cold or marine use. They are equally at home in your home, for background music, hi-fi, or home theater.

All models in the Voyager line are true two-way designs with all acoustic parts sealed and gasketed against penetrating weather.

Basic Hookup

1. Connect the speaker terminals to the amplifier speaker outputs. connections, be sure to connect

+ to + (red) and to (black).

Note: The Voyager Metro requires connection of both left and right speaker wires to the one speaker. amplifier or receiver

Checking the Speaker Connections

It is important that your speakers are hooked up with similar polarity or in phase. A simple listening test will tell you if your speakers are connected properly. Place the speakers face to face, as closely together as possible. While listen