Qualified ALTINEX service personnel, or their authorized representatives, must perform all
For best results, place the PNP515/517 in a dry area away from dust and moisture.
To prevent fire or shock, do not expose this unit to water or moisture. Do not place the
PNP515/517 in direct sunlight, near heaters or heat-radiating appliances, or near any liquid.
Exposure to direct sunlight, smoke, or steam can harm internal components.
Handle the PNP515/517 carefully. Dropping or jarring can damage the unit.
Never place fingers inside the openings of the unit. This action could cause serious injury due to sharp edges inside the PNP515/517.
Do not place heavy objects on top of the
PNP515/517. Do not use excessive force to push down on the top of the unit.
To turn off the main power, disconnect the power cord which powers the AC socket on the
PNP515/517 pop-up panel. The power outlet used should be installed as near to the equipment as possible and should be easily accessible.
ALTINEX recommends using wall outlets with a
Ground Fault Circuit Interrupter (GFCI) for maximum protection.
Install all cables according to the instructions. Do not force or pull out any cable or power cord that is attached to the PNP515/517.
Surfaces should be cleaned with a dry cloth.
Never use strong detergents or solvents such as alcohol or thinner. Do not use a wet cloth or water to clean the unit.
1.4 FCC NOTICE
1.2 INSTALLATION PRECAUTIONS
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions found herein, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his expense.
Any changes or modifications to the unit not